Fabric is where most garment programmes quietly fail. The sample is approved on a swatch, the bulk arrives on a different lot, and the shade, hand-feel or shrinkage no longer matches the spec. Everything else in this hub follows from that risk.
What to lock before you place an order
- Composition and yarn count — written as percentages with a tolerance, not as a trade name.
- Weight (GSM) and width — with the measurement method stated, because GSM measured on greige and on finished fabric differ.
- Shrinkage after wash — the single most common cause of a failed bulk delivery.
- Colour fastness — to washing, rubbing and light, with the standard named (ISO or AATCC).
- Hand-feel reference — a physical retained swatch, signed by both sides, beats any adjective.
The guides
- Fabric guide: types, blends and sourcing — the reference piece: fibre families, blends, and how each behaves in production.
- Fabric sourcing for B2B buyers — the buying process, from mill selection to lot approval.
- Textile knowledge for buyers — the technical vocabulary you need to write a spec a mill cannot misread.
- MOQ guide for custom garment manufacturing — why fabric choice, not sewing capacity, usually sets your minimum.
Why fabric sets the MOQ
A factory can cut 50 pieces of a garment. A mill will not weave or knit 50 metres of a custom fabric. That is why the minimum order conversation usually starts with the fabric specification, not with the garment: the moment you choose a custom dye lot, the mill minimum becomes your floor.
If you want a low minimum, the practical route is a stock fabric in a standard colourway, with your differentiation coming from the pattern, trims and finishing. If the fabric is the product, plan the programme around the mill minimum instead.
The specification sheet: fields that decide acceptance
| Field | Why it decides the outcome | How to write it |
|---|---|---|
| Fibre composition | Drives price, hand-feel and care labelling | Percentages with a tolerance, e.g. 95% cotton / 5% elastane ±2% |
| Construction | Single jersey, rib, interlock, twill, dobby — not interchangeable | Name the construction plus yarn count |
| Weight | Determines drape and whether the garment holds shape | GSM with the state measured: greige, finished or washed |
| Width | Sets marker efficiency and therefore fabric consumption | Usable width in cm, tube or open width |
| Shrinkage | The most common reason a bulk delivery is rejected | % length and width after a named wash cycle |
| Colour fastness | Decides whether the garment survives its first customer wash | Grade against ISO 105 or AATCC, per condition |
| Hand-feel reference | Adjectives do not travel; swatches do | A retained, signed swatch held by both sides |
Testing to request before bulk
- Shrinkage after three washes — not one. Most relaxation happens in the first two cycles.
- Colour fastness to washing, rubbing and light — the three that generate returns.
- Pilling — especially on wool blends and low-twist yarns; grade it rather than describing it.
- Dimensional stability of the seam — a fabric that passes flat can still pucker at the seam after wash.
- Substance check against the approved lot — weight drift between lots is common and rarely volunteered.
Where fabric sourcing goes wrong
The typical failure is not a bad mill. It is an approved swatch that never became a written specification, followed by a bulk lot that meets the mill’s own standard rather than the buyer’s. The second most common failure is a last-minute colour change that moves the order to a different dye lot, and with it the hand-feel the sample was approved on. Both are prevented by the same discipline: every attribute that matters is written down, measured the same way on both sides, and tied to a retained physical reference.
Cogarm has manufactured custom knitwear and woven garments in Dongguan, Guangdong, China since 2006. Minimum order is 100 units per style and colourway.
